Sump Pumps · installation, repair, replacement
Sump Pump Repair and Replacement in Yakima, WA
Spring runoff finds the lowest point of your house. A working sump pump is what meets it there, and Joe's crew installs, repairs and replaces them.
Chapter 01
The pit at the lowest point of the house
A sump pump is a small, powerful device that sits in a pit at the lowest point of your basement or crawl space. It collects excess groundwater and pumps it out before it can flood the house. When heavy rain, melting snow or rising groundwater push toward the foundation, it switches on automatically and sends the water away from the walls.
In the Yakima Valley the busy season is spring runoff. A pump that has sat quiet all winter is asked to work hard, and a pump that has quietly failed shows itself as water on the floor, a damp smell, or mold on the lower walls.
Black ABS drain and vent runs through floor joists in a home plumbed by All Valley Plumbing
Repair or replace: reading what the pump is telling you
Like any appliance, a sump pump does not last forever. Most pumps last about 7 to 10 years, and frequent use or poor maintenance shortens that. We start by looking at the age of the pump, then at how it behaves: how often it cycles, what it sounds like, and whether it clears the pit as fast as it should.
Sometimes the pump only needs attention. A float switch that is stuck or worn, a damaged impeller, a partial blockage, or an electrical fault are all repairs, and Joe's crew can diagnose them on the spot. When the pump loses power during storms, a backup battery is often the right addition.
When the pump is old, rusted or outmatched, we replace it and make sure the pit and the discharge are set up so the new unit does its job.
Chapter 03
A small investment against a flooded basement
A working sump pump keeps a basement or crawl space dry, cuts the moisture that feeds mold and mildew, and protects the foundation from water working into cracks. A well-maintained system is also a selling point when you list the house. Keeping moisture out even eases the load on the heating and cooling system.
We assess your system, recommend the right solution and make sure the pump is ready before the snow melts. If a pump keeps tripping on water that has nowhere else to go, we may also look at the lines beneath the house, and our crew can take it from there.
All Valley Plumbing is a Washington licensed plumbing contractor, number ALLVAVP772L2. Call (509) 268-4012 for a free local estimate.
Read the pump
Signs it needs replacing, and signs it only needs a repair
If water keeps reaching the pit and you cannot tell where it comes from, our leak detection crew can trace it, and the sewer line work picks up where the pit ends. Finishing a basement? Read about remodeling plumbing.
Replace it
Age of the pump
More than a decade old: replace it before it fails, not after.
Frequent cycling
A pump that runs constantly, even in dry weather, is wearing out.
Strange noises
Grinding, rattling or humming usually means internal parts are failing.
Rust or corrosion
Water and metal do not mix well. Visible rust is deterioration.
Falls behind in storms
If it cannot keep up in heavy rain, it is no longer powerful enough.
Repair it
Will not turn on
In wet conditions that means an electrical issue or a stuck switch.
Will not shut off
Usually a new float switch or an adjustment to the pit.
Vibrates hard
The impeller could be damaged.
Slow to clear water
A partial blockage is the likely cause.
Loses power in storms
A backup battery installation may be the answer.
Catching these early extends the life of the pump and keeps the basement dry. Send the job details and the office will call back.